Kraken Bond now offers SF 404 AeroSeal Gasket Foam for Drywall & Framing, a 14 oz gun-applied polyurethane foam that closes air leaks where drywall meets framing, a spot that is hidden for good once the board goes up.
Kraken Bond, a Chantilly, Virginia, manufacturer of chemical products for construction and industrial work, announced Nov. 12, 2026, that its SF 404 AeroSeal Gasket Foam for Drywall & Framing is now available. The one-component polyurethane gun foam comes in a 14 oz can and is aimed at air leakage at the joint between drywall and framing. The company timed the launch to builders wrapping up interiors before year-end final inspections.
Air tightness is a growing factor in residential work. The 2021 International Energy Conservation Code from the International Code Council requires air leakage testing on new homes. Under the prescriptive path, homes must reach a maximum of 5 ACH50 in Climate Zones 0 to 2 and a maximum of 3 ACH50 in Climate Zones 3 to 8, per Section R402.4.1.3. Adoption depends on the state and local jurisdiction. Because blower door tests usually happen late in the build, after drywall is up, leaks behind finished walls can be hard and expensive to fix if the house fails.
Common leakage paths in light-frame construction include top and bottom plates, wall-to-floor and wall-to-ceiling connections, and seams between studs and drywall. A failed test can mean remediation and a retest, pushing back project closeout. Sealing those joints before hanging drywall treats them while they can still be reached.
The foam’s low-expansion formula is meant to help keep drywall from bowing or distorting, and it does not shrink. High elasticity lets it move with the structure and recover after minor compression, and the gun application gives installers control over bead placement. It is tack-free in about 7 minutes, fully cured in 24 hours, and can be used on metal or wood studs. It also adds supplemental thermal and sound insulation. Application temperatures run from 41 to 86 degrees Fahrenheit, and shelf life is 18 months. Contractors can buy single cans or multi-packs of up to 48 cans.
Kraken Bond points out that the foam is not a drywall adhesive, does not take the place of mechanical fasteners and is not for structural bonding. Used within a complete air-sealing system, the company says it may help support better blower door results.
“The drywall-to-framing joint is one of the last chances to seal the envelope before it is covered and hidden for the life of the building,” said a spokesperson for Kraken Bond. “A low-expansion formula matters here because it fills the gap without pushing against the drywall, which helps keep the surface flat and the seal continuous.”
The product is meant for framers, drywall and insulation installers, general contractors and smaller renovation firms on new residential and light-frame projects, and it also fits renovations where walls have been opened.
Key features include:
- Low-expansion, one-component polyurethane gun foam, 14 oz can (SF 404)
- No shrinkage; elastic, recovers after minor compression
- Tack-free in about 7 minutes, full cure in 24 hours
- Suits metal or wood studs; adds supplemental thermal and sound insulation
- Application range 41 to 86 degrees Fahrenheit; 18-month shelf life
- Single cans or multi-packs up to 48 cans





